See the diagram below.
*The dimensions of the mounting part in the diagram below are for reference only, and should be used after considering the amount of O-ring compression, compression ratio, etc.
Yes. It can receive pressure.
Please contact us for availability.
The pressure resistance is up to 980kPa, but please use it within the rated range and in an environment where impact pressure such as water hammer is not applied.
There is almost no output fluctuation within our recommended power supply voltage (11 to 16V).
Refers to the output span voltage. When showing error and accuracy, it is indicated as a percentage of full scale.
Offset voltage deviation occurs. In the worst case, the pressure sensor chip may be destroyed.
Gauge type pressure sensors detect differential pressure against atmospheric pressure. Therefore, the output of the pressure sensor is not affected by everyday fluctuations in atmospheric pressure.
* Accurate pressure detection cannot be performed if the atmospheric pressure inlet provided on the side of the pressure sensor package is blocked.
If sudden negative pressure is applied repeatedly, some oil may leak out, but since the purpose is to protect the sensor chip, there is no functional problem as long as there is enough oil in the sensor chip.
Accurate water pressure cannot be transmitted to the sensor chip, which may lead to output errors.
Please use JIS standard, P-6 size.
Assuming M4 size.
The pressure range, output voltage range, and power supply voltage range can be customized, so please feel free to contact us.
It is not a waterproof type. Please use it in air.
Accuracy is guaranteed up to 50°C. It is possible to use more than that, but it will be out of the temperature compensation range.
The detection medium of the water level sensor is assumed to be “domestic water”